Cart
Your shopping cart is empty! 
D-Link Switch 444mm D-Link DGS-1210-28P/ME/E 4*SFP/24*GE PoE+ retail
To purchase this product you must be registered in our system.
Specification
ac input frequency: 50/60 Hz
ac input voltage: 100 - 240 V
access control list (acl): Yes
access control list (acl) ingress: 256
access control list (acl) rules: 256
active link detection: Yes
arp inspection: Yes
authentication type: AAA, RADIUS, TACACS+
auto mdi/mdi-x: Yes
auto-negotiation: Yes
basic switching rj-45 ethernet ports quantity: 24
basic switching rj-45 ethernet ports type: Gigabit Ethernet (10/100/1000)
bpdu filtering/protection: Yes
broadcast storm control: Yes
cable types supported: Cat5, Cat5e
compliance certificates: BSMI, CB, CCC, CE, Federal Communications Commission (FCC), Low Voltage Directive (LVD), VCCI
configuring location settings (cli): Yes
console port: RJ-45
copper ethernet cabling technology: 10BASE-T, 100BASE-TX, 1000BASE-T
depth: 210 mm
dhcp features: DHCP client, DHCP relay, DHCP server, DHCP snooping
ethernet lan data rates: 1000 Mbit/s
fanless: No
fiber ethernet cabling technology: 1000BASE-X
flash memory: 32 MB
flow control support: Yes
form factor: 1U
forwarding rate: 41.7 Mpps
full duplex: Yes
garp vlan registration protocol (gvrp): Yes
half duplex: Yes
heat dissipation: 857.98 BTU/h
height: 44 mm
igmp snooping: Yes
input voltage: 100 - 240 V
installed sfp modules quantity: 4
internal memory: 256 MB
ip-mac-port binding: Yes
ipv4 & ipv6 features: Dual stack IPv4/IPv6, ICMPv6, IPv4/IPv6 access-control list (ACL), IPv6 Path MTU Discovery, IPv6 Telnet
ipv4 routes: 64
ipv6 routes: 32
led indicators: Activity, Fan fail, Link, Power, Speed
link aggregation: Yes
loop protection: Yes
mac address table: 16000 entries
mean time between failures (mtbf): 331669 h
memory type: DDR3-SDRAM
mib support: • RFC1212 Concise MIB Definitions • RFC1213 MIB II • RFC1215 MIB Traps Convention • RFC1065, 1151, 2578 MIB Structure • RFC1493 Bridge MIB • RFC1157, 2573, 2575, 2576 SNMP MIB • RFC3418 SNMPv2 MIB • RFC2819 RMON MIB • RFC2021 RMONv2 MIB • RFC1643, 1650, 2665 Ether-like MIB • RFC2674 802.1p MIB • RFC 2233 Interface Group MIB • RFC 2618 RADIUS authentication client MIB • RFC 2620 RADIUS accounting client MIB • RFC3289 D-Link Zone Defense MIB • RFC4022 MIB for TCP • RFC4113 MIB for UDP • PoE MIB • DDP MIB • LLDP-MED MIB
multicast features: Controllable multicast
multicast listener discovery (mld) snooping: MLD v1, MLD v2
multicast support: Yes
networking standards: IEEE 802.1D, IEEE 802.1Q, IEEE 802.1p, IEEE 802.1s, IEEE 802.1w, IEEE 802.1x, IEEE 802.3ab, IEEE 802.3ah, IEEE 802.3at, IEEE 802.3az, IEEE 802.3i, IEEE 802.3u, IEEE 802.3x, IEEE 802.3z
noise level: 52.9 dB
number of fans: 2 fan(s)
number of ip interfaces: 4
number of multicast groups filtered: 256
number of queues: 8
number of static routes: 96
number of vlans: 4094
operating relative humidity (h-h): 10 - 90%
operating temperature (t-t): -5 - 50 °C
packet buffer memory: 1.5 MB
password protection: Yes
port mirroring: Yes
power consumption (max): 251.5 W
power over ethernet (poe): Yes
power over ethernet (poe) ports quantity: 24
power protection features: Surge protection
power source: AC
quality of service (qos) support: Yes
queue scheduling algorithms: Strict Priority Queue (SPQ), Weighted Round Robin (WRR)
security algorithms: EAP, SNMP, SNMPv2, SNMPv3
spanning tree protocol: Yes
ssh/ssl support: Yes
static route: Yes
storage relative humidity (h-h): 0 - 95%
storage temperature (t-t): -40 - 70 °C
store-and-forward: Yes
sustainability certificates: UL ECOLOGO
sustainability compliance: Yes
switch layer: L2/L3
switch type: Managed
switching capacity: 56 Gbit/s
system event log: Yes
total power over ethernet (poe) budget: 193 W
traffic classification: Yes
virtual lan features: MAC address-based VLAN, Port-based VLAN, Private VLAN, Protocol-based VLAN
vlan support: Yes
web-based management: Yes
weight: 3.34 kg
width: 440 mm
Description
| Gigabit Managed Switches The DGS-1210/ME Series Gigabit Managed Switches provide a diverse range of Gigabit port densities to accommodate various enterprise and public sector connectivity needs. With optional PoE to conveniently power edge devices, SFP ports to extend network connectivity, and advanced Layer 2 functionalities, the DGS-1210/ME Series is ideal for any enterprise access layer or large multi-site deployment and allows businesses to build a more secure and efficient network with advanced network security features and QoS. Flexible Hardware Design Wide range of port and media types, including 10/100/1000BASE-T RJ-45 ports, 100/1000 Mbps GbE/SFP combo ports, and 100/1000 Mbps SFP ports. High Switching Capacity and PoE Budget Up to 104 Gbps switching capacity with a maximum PoE budget up to 370W. Layer 2 with Layer 3 Lite features Equipped with a complete lineup of L2 features, and supports IP interfaces, ARP, IPv6 neighbor discovery (ND) and default routing. Network Security D-Link’s innovative Safeguard Engine™ protects the switches against traffic flooding caused by malicious attacks. Simplified Management Simple management through user-friendly web configuration or command line interface (CLI) via Telnet or SSH for ease-of-use. Limited Lifetime Warranty & Next Day Service Register to enjoy D-Link Limited Lifetime Warranty support, with complimentary next business day advance replacement service included. Gigabit Performance The DGS-1210/ME Series Gigabit Managed Switches come in a variety of port setups, including Gigabit Ethernet RJ-45 and SFP ports. The DGS-1210-10P/ME, DGS-1210-28P/ME and DGS-1210-52MP/ME switches feature Power over Ethernet (PoE), allowing compatible devices to be installed and powered in remote locations without immediate access to power outlets. Efficient and Resilient Networking For mission critical environments, the DGS-1210/ME Series Gigabit Managed Switches support IEEE 802.1D 2004 edition, 802.1w, and 802.1s Spanning Tree Protocols (STP). The Spanning Tree Protocol allows the switches to participate in Spanning Tree topology, providing an alternative Layer 2 path in the event of a network failover. The switches also support IEEE 802.3ad link aggregation, which enables multiple ports to be grouped to form a single virtual port, increasing bandwidth and redundancy for higher availability. This series furthermore features IEEE 802.1p Quality of Service (QoS), allowing for real-time traffic classification into Weighted Round Robin (WRR) and strict priority levels mapped to 8 queues. Advanced traffic classification parameters allow the network to be tuned for flexible configurations for specific multimedia applications such as VoIP or IPTV. Multicast Applications The DGS-1210/ME Series features a full set of L2 multicast functions, including IGMP snooping, IGMP filtering, fast leave, and multicast traffic configuration for specific ports. With L2 multicast support, the DGS-1210/ME Series is ready and capable of handling growing IPTV applications. Host-based IGMP/MLD snooping allows for multiple multicast subscribers per physical interface, and ISM VLAN sends multicast streams in a multicast VLAN, saving bandwidth on the backbone. Additionally, ISM VLAN profiles allow users to bind or replace the predefined multicast registration information to subscriber ports quickly and easily. Traffic & Bandwidth Control Integrated bandwidth control allows network administrators to define the throughput levels for ingress and egress bandwidth. It provides a minimum granularity of 64 Kbps for ingress port and flow-based bandwidth control, and a minimum granularity of 64 Kbps for egress queue bandwidth. The DGS-1210/ME Series also supports traffic control, which optimizes performance by dropping packets when exceeding a set threshold, while port mirroring helps administrators facilitate traffic diagnostics and track network performance. The DGS-1210/ME Series also provides IGMP snooping with IGMP authentication to prune multicast traffic and to optimize available bandwidth. Management Capabilities A user-friendly web interface gives administrators access to advanced management features such as DHCP auto-configuration. This enables switches to load their configuration from a TFTP server once they have been assigned an IP address, allowing central management of device configurations. The switches support Link Layer Discovery Protocol (LLDP), which advertises the device’s capabilities and identity to the local network, allowing administrators to better manage their network topology. Each port also supports cable diagnostics, which can be used to troubleshoot cable length and functionality problems remotely, resulting in lower management overheads. Security & Authentication The DGS-1210/ME Series supports IEEE 802.1X port-based/host-based access control, guest VLAN, and RADIUS/TACACS+ authentication for strict access control to the network. The IP-MAC-Port Binding (IMPB) feature allows administrators to associate a source IP address with a designated MAC address and also offers the flexibility to define the port number to enhance user access control. The built-in D-Link Safeguard Engine™ protects the CPU from broadcast, multicast, and unicast flooding by automatically trapping packets and logging events in these situations. In addition, the Access Control List (ACL) feature enhances network security and switch performance. Free Next-Business-Day Service Enjoy our free Next Business Day service, as standard, to replace faulty equipment quickly. Our rapid-response technical support is designed to ensure businesses get the best support for their unique environment. Our extended warranty and enhanced service packages increase the lengths of warranties and further minimises downtime. You can even opt for our Same Business Day Service which guarantees the delivery of the replacement product within 4 hours of confirmation of product failure. |
DCP SIA © 2025
Powered By:
